Print this page
The SFP Module 1000BASE-T1 H-MTD is a solution to convert between 1000BASE-T1 and SGMII using an H-MTD connector. It fits into a standard SFP (Small Form-factor Pluggable) slot and provides an Automotive Ethernet interface (100/1000 Mbit/s full-duplex, on one single twisted pair cable). When plugged into approved devices, Hardware-in-Loop (HiL) systems, and test benches with compatible chassis, the SFP Module has to be configured to Automotive Ethernet (100- or 1000BASE-T1) after power-up.
The device features four dip switches for the following functionalities:
- Dip switch no. 1: Slave / Master setting
- Dip switch no. 2: 100/1000Mbps
- Dip switch no. 3: IEEE/Legacy mode
- Dip switch no. 4: SingleSendS/MultipleSendS mode
The device can be used together with other Technica Engineering products, like the Switch-Based products or Capture Module products , or other approved chassis of Technica partners. However, the SFP Modules do not work as a “plug-and-play” solution. To set up the SFP Module, the user must be able to interact with the registers of the Phy via I˛C and get in touch with Marvell (the PHY manufacturer) to receive the NDA-protected PHY-register setting datasheet to initialize the Phy. Some commercially available devices already recognize and work with the SFP modules successfully, please check the supported devices together with us.
 |
 |
Facts
- 1 × DIP switch
- 1 × Status-LED
- Marvell 88Q2112 A2 PHY
- H-MTD connector for Automotive Ethernet
- Fits into a standard SFP-slot
- IP 20 rating
- Voltage requirements: 3.3 volt DC
- Size: 68 × 14 × 14 mm
Features
- Converts between 1000BASE-T1 and SGMII
- Configuration via DIP switches
- DIP-Switch 1: Master/Slave
- DIP-Switch 2: HalfOut/FullOut
- DIP-Switch 3: IEEE-/Legacy-mode
- DIP-Switch 4: SingleSendS/MultipleSendS
- Supports I2C for internal register access
Use Case
 |